Table of Contents
Advertisement
FIGURE 20. Tank Top Plumbing with Cap
NOTE:
On tanks that do not require injection pump recirculation, use the provided cap to seal the open port.
Refer to the "System Diagrams" on page 45 to determine which tanks require injection recirculation
plumbing.
CALIBRATOR MOUNTING
FIGURE 21. Calibrator Assembly
Attach Calibration
Assembly to Pump
Outlet Using
Provided M100
Gasket and M100
Clamp
NOTE:
For single pump systems this valve assembly replaces the existing outlet fitting on the calibrator.
Attach the valve and fitting assembly directly to the check valve for the single pump system.
P/N 016-0171-675 Rev. A
Overflow
Elbow, M100 x 1" HB
Port
1" MNPT to
M100
M100 to 1"
MNPT
M100 Gasket and Clamp
Calibrator
and
Plumbing
Assembly
To Injection
Point
Pump
Cap
Tank
Recirculation
INSTALLATION
19
Advertisement
Table of Contents
