Table of Contents
Advertisement
C
3
HAPTER
FIGURE 46. Logic Power and CAN Connection
Logic Power and
CAN Connection
9. Connect the logic power and CAN connections of the chassis cable to the machine power and CAN
connections.
PUMP CABLE INSTALLATION
1. Connect the pump ECU cable (P/N 115-2500-017) to the chassis cable (P/N 115-2500-016).
2. If using two pumps, connect the second pump ECU cable.
3. Locate the CAN end cap connector that is supplied with the chassis cable.
4. Plug the CAN end cap connector to the unused round connector on the pump ECU cable (located on the right
pump if two pumps are installed).
5. Connect the remaining open connectors of the Pump ECU cable to the injection pumps.
36
ICD Sidekick Pro Injection for Case Trident Installation Manual
Advertisement
Table of Contents
