CHAPTER
3
INSTALLATION PREPARATION
Verify Software version 2.8 or higher is present on the Raven Viper 4+, or that Version 30 or higher is present on
the Case IH Pro 700 controller if equipped.
SYSTEM CLEANOUT
1. Rinse the system with at least 100 gallons of clean water.
2. Remove all pressure from plumbing components.
3. Drain out the main carrier tank, rinse tank, and boom plumbing.
BRACKET PREPARATION
1. Remove the wires from three studs on the lower cross tube.
FIGURE 1. Stud Locations on Lower Cross Tube
2. Using an angle grinder with a cutoff disc, remove the three studs.
HYDRAULIC HOSE REPLACEMENT
IMPORTANT:
Follow equipment safety precautions for removing hydraulic lines. Ensure the boom center rack is lowered to
the lowest level to prevent accidental lower while replacing hydraulic hoses.
P/N 016-0171-675 Rev. A
I NSTALLATION
C H A P T E R 3
Stud Locations
Wires
7