11.10
Lubricating the steering head bearing
11.11
Removing the headlight mask
–
Position the handlebar, mount and tighten screws
Guideline
Screw, handlebar
clamp
E01348-10
–
Mount handlebar cushion
E01347-14
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated in the
course of removal and installation of the lower triple clamp.
H02387-01
–
Remove cable tie(s)
–
Remove the headlight mask towards the front and hang it carefully
to the side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
E01344-12
SERVICE WORK ON THE CHASSIS 11
M8
25 Nm (18.4 lbf ft)
1
A
in area
.
p. 43)
(
p. 40)
(
p. 42)
1
.
2
.
p. 38)
45