Condition
The engine is at operating temperature.
Preparatory work
–
Park the motorcycle on a level surface.
–
Position an appropriate container under the engine.
Main work
–
Remove gear oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
Guideline
Drain plug for gear oil
E01397-10
–
Remove filler plug
Gear oil
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
E01396-12
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
SERVICE WORK ON THE ENGINE 17
1
.
1
with a new seal ring.
M8
12 Nm (8.9 lbf ft)
2
and fill up with gear oil.
0.37 l (0.39 qt.)
Gear oil (API GL‑5,
SAE 75W/90)
(
2
.
p. 92)
p. 110)
93