11.13
Lubricating the steering head bearing
11.14
Removing the start number plate
11.15
Installing the start number plate
–
Using a plastic hammer, tap lightly on the upper triple clamp to
avoid stresses.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steer-
ing stem
Finishing work
–
Check steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Mount the handlebar cushion.
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated in the
course of removal and installation.
H02387-01
–
1
Remove screw
–
Disconnect the brake line at the start number plate. Take off the
start number plate.
S04535-10
–
Connect the brake line at the start number plate.
–
Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
S04536-10
SERVICE WORK ON THE CHASSIS 11
1
.
M8
20 Nm (14.8 lbf ft)
2
.
M8
20 Nm (14.8 lbf ft)
p. 48)
(
p. 45)
(
p. 46)
.
1
.
Loctite
®
243™
p. 42)
49