Lubricating The Steering Head Bearing; Removing The Start Number Plate; Installing The Start Number Plate - GAS GAS MC 450F 2021 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.13
11.14
11.15
52

Lubricating the steering head bearing

H02387-01

Removing the start number plate

A00778-10

Installing the start number plate

A00779-10
Guideline
Screw, top triple clamp
–
Check the steering head bearing play. (
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated in the
course of removal and installation of the lower triple clamp.
–
1
Remove screw .
–
Unhook the start number plate from the brake line and remove it.
–
Position the brake line in holders
–
Position the start number plate. Mount and tighten screw
The holding lugs engage in the fender.
M8 20 Nm (14.8 lbf ft)
p. 51)
p. 44)
( p. 48)
( p. 49)
A
on the start number plate.
1
.