Running In The Engine; Preparing The Vehicle For Difficult Operating Conditions - GAS GAS TXT Racing 125 2020 Owner's Manual

7 PREPARING FOR USE
–
Get used to the handling characteristic of the motorcycle on suitable terrain before undertaking a more challenging
ride.
–
Also, ride as slowly as possible and in a standing position to get a better feel for the motorcycle.
–
Do not undertake any off-road trips that exceed your ability and experience.
–
Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
–
Do not carry the luggage.
–
The maximum permissible overall weight and the maximum permissible axle loads must not be exceeded.
–
Check the spoke tension. (
Guideline
The spoke tension must be checked after half an hour of operation.
–
Run the engine in. (
7.2
–
During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
–
Avoid fully opening the throttle!
–
Check the idle speed regularly.
Guideline
Idle speed
»
7.3
–
Clean the air filter and air filter box. (
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
»
22
Info
When offroad, it is recommended that you are accompanied by another person on another vehicle so that you
can help each other.
p. 79)
p. 22)

Running in the engine

During the first three operating hours
During the first five operating hours
Info
The idle speed may change during the run-in time.
If the idle speed changes:
– Carburetor – adjust the idle speed.

Preparing the vehicle for difficult operating conditions

Info
Use of the vehicle under difficult conditions, such as on sand or on wet, dusty and muddy surfaces/offroad, can
result in significantly increased wear of components, such as the air filter, drive train, brake system, or suspension
components. For this reason, it may be necessary to inspect or replace parts before the next scheduled service.
Info
Check the air filter approx. every 30 minutes.
If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
< 70 %
< 100 %
900 ... 1,100 rpm
( p. 89)
p. 50)