Data Usage - NTT docomo MONO MO01J Instruction Manual

2
Enter a network SSID of Wi-Fi network to add
Select security
･
Security can be selected from [None], [WEP], [WPA/WPA2
PSK] or [802.1x EAP].
3
Enter additional security information as
required → [SAVE]
Connecting other devices with Wi-Fi Direct
Connect between Wi-Fi Direct devices without routing an access
point etc.
･
Set Wi-Fi to ON in advance.
･
To transfer data such as videos or still images using Wi-Fi Direct,
install an application compatible with data transfer via Wi-Fi Direct.
1
From the Home screen, [Settings]
[Advanced] [Wi-Fi Direct]
→ →
･
When a Wi-Fi Direct device does not appear, tap [SEARCH
FOR DEVICES].
2
Select a Wi-Fi Direct compatible device to
connect
Advanced Wi-Fi settings
1
From the Home screen, [Settings]
[Advanced]
→
2
Set each item
Network notification : Set whether to notify when Wi-Fi open
network is available.
→ Keep Wi-Fi on during sleep : Set whether to keep or
disconnect Wi-Fi connection when the terminal is in sleep mode.
You can set to keep the connection only when charging the
battery, too.
･
By default, "Always" is set. When not charging with "Only when
plugged in" selected, or "Wi-Fi will be disconnected after a
period of inactivity" is selected, connected Wi-Fi network will
be disconnected after approximately 15 minutes from the
screen backlight turns off. When the sleep mode is canceled,
the terminal connects the Wi-Fi network automatically.
Avoid poor connections : Set whether to not use Wi-Fi network
if it is unstable.
Install certificates : Install certificates.
Wi-Fi Direct :
WPS Push Button :
WPS Pin Entry :
→ [Wi-Fi] →
Passpoint : Set whether to connect to available Passpoint
access point automatically when Wi-Fi is ON.
MAC address : Display MAC address.
IP address : Display IP address.

Data usage

You can enable or disable data communication via mobile network,
set limit of data communications, etc.
1
From the Home screen, [Settings]
[Wi-Fi]
→ →
usage]
87
P.87
→
→ P.86
→ P.86
[Data
→
Settings