NTT docomo MONO MO01J Instruction Manual page 110

Bluetooth function On/Off
Set Bluetooth to On to use Bluetooth function. When you do not use
Bluetooth, set it to Off in order to reduce the battery power
consumption.
･
When it is On, is displayed on the status bar.
･
Turning the power OFF does not change Bluetooth On/Off setting.
1
From the Home screen, [Settings]
2
Tap / to set it On (
Connecting Bluetooth devices
To connect the terminal and Bluetooth device, pairing is needed.
･
Depending on Bluetooth device, entering passcode (PIN) may be
required for pairing.
･
Bluetooth devices may perform just pairing, or pairing and then
connecting consecutively.
･
Up to 5 devices can be connected at the same time. Depending on
profile, operation may not be correct or number of devices that can
be connected at the same time may be different.
･
Allow a Bluetooth device to be detected in advance.
1
From the Home screen, [Settings]
2
Tap to set it On (
3
Tap a detected Bluetooth device
･
If a Bluetooth device you want to connect is not displayed, tap
[Refresh].
→
4
Confirm appeared passcode (PIN)
→ [Bluetooth]
)/Off ( )
[Bluetooth]
→
)
[PAIR]
→
■ When connection is requested from another
Bluetooth device
If a Bluetooth pair setting request screen appears, confirm a pass
code (PIN) and tap [PAIR].
Sending or receiving data to or from
Bluetooth device
You can send data such as images or contacts, and receive data from
a Bluetooth device.
･
Allow a Bluetooth device to be connected or to be detectable in
advance.
Send a file
1
From the sharing menu of each application,
[Bluetooth]
2
Tap a Bluetooth device
Open the Notification panel to check completion of sending.
Receiving files
1
Sending files from a Bluetooth device
2
After file incoming notice is received, open the
Notification panel
file] → [ACCEPT]
･
To check received files, from the Home screen, tap [Settings]
→ [Bluetooth] → →
108
[Bluetooth share: Incoming
→
[Show received files].
Data communication