Table of Contents
Advertisement
4
Take out the docomo nano UIM card from the
tray
5
Insert the tray into the terminal
･
Check the orientation of tray to install correctly.
6
Close the docomo nano UIM card/microSD card
slot cover
P.20
→
Information
◆
･
Please be careful not to touch or scratch the IC when you handle
the docomo nano UIM card. Also, be aware that trying to insert or
remove the docomo nano UIM card with excessive force may cause
it to break.
･
For removing/inserting the tray from/into the docomo nano UIM
card slot, do not remove or insert forcibly. Doing so may damage
the tray.
･
Nameplate sheet is inserted under the docomo nano UIM card/
microSD card slot. Do not pull out the nameplate sticker attached
on it because it will be requested at a DOCOMO specified repair
office when the terminal is damaged etc.
･
If the SIM ejector is lost or damaged, you can use a paper clip
instead.
Charging
Precautions on charging
･
If you use applications while charging, it may take time to complete
→
P.26
charging or charging may not complete due to drop-off of battery.
･
It is normal for the terminal or AC adapter to become warm while
charging. When the terminal becomes warm, charging may stop
temporarily for the safety. When the terminal becomes extremely
hot, stop using immediately.
･
If you start charging with the battery run out, the terminal may not
activate immediately after the power is turned on. In that case,
charge with the terminal kept turned off for a while, then turn the
power on.
･
For charging time, see "Main specifications".
Internal battery life
･
The internal battery is a consumable part. Each time the internal
battery is recharged, the battery usage time per one charge
gradually decreases. Calling etc. for a long time while charging may
shorten the lifetime of the internal battery.
･
You can check performance (charging ability) of the internal battery
from "About phone".
27
→
P.128
→
P.103
Before Using the Terminal
Advertisement
Chapters
Table of Contents
