Initial Set-Up - Lightspeed Redcat Access LSRCA 1881 User Manual

PLACE THE FLEXMIKES IN THE ACTIVATE
STATION
Prior to full operation, the microphones should be fully charged (at least 8 hours) to
ensure optimum performance. In most cases, there should be enough battery life for
initial setup and testing.
NOTE: If Activate Station was purchased with your Redcat, the Activate will be the charger
for microphones rather than the FMCC.
1. Insert the Flexmike(s) into the Activate Station.
2. The Flexmike(s) will power on and the charging light will turn red to indicate normal
charging. When fully charged, the charging light will turn green. The blue microphone
1 or 2 light will blink for several seconds as it establishes a link, then turn solid.
3. For systems purchased with optional Sharemikes or handheld remotes, they can be
charged by using the USB charging ports on the back of Activate Charging Station..
The charging light will turn red to indicate normal charging. When fully charged, it will
turn green.
If your Activate System was purchased together with the Redcat, all components were
registered (paired) together at the factory.
The components are registered and ready for operation when:
• Microphone(s) has a solid blue #1 or #2 light
• Activate Station has a solid green link light
NOTE: When Activate Station is powered on and registered to Redcat, it locks out Master
Volume and Tone controls on the Redcat.
www.hearandlearn.com.au
Redcat Access is part of the
Offices Australia wide (03)93709355
www.hearandlearn.com.au technology family.
31