Lightspeed Redcat Access LSRCA 1881 User Manual page 20

5. OPERATING THE FLEXMIKE
Once the Flexmike is charged, follow these steps to set it up for use.
1. Remove the Flexmike from the
cradle charger and put it on by
connecting the magnetic clasps
behind your neck. Adjust the
lanyard so that the top of the
Flexmike is at the collarbone.
2. The Flexmike will automatically
power on and mute when it is
removed from the charger. If Redcat
has been powered down, this will
automatically power on the Redcat
as well.
2. The microphone volume on the
Flexmike is set at the factory to the
midpoint.
3. While speaking in a normal voice,
fine-tune the microphone volume
on top of the Redcat up or down.
Proper volume level should be as
follows:
• Your voice should be clearly heard
by another person on the other
side of the room.
• You should barely be able to hear
your own voice.
• There should not be any audio
"feedback" or squealing outside of
2-3 feet (if there is, turn the volume
down slightly).
REMEMBER: This equipment supplements
the user's voice so they are able to speak
in a conversational tone. Having the
volume set too high will result in feedback
and listener fatigue.
4. Once initial volume level is set,
walk around the room and listen for
overall audio quality.
5. If further fine-tuning is required,
you may need to adjust the Tone
Control on the top of the Redcat.
20
Redcat Access is part of the
Offices Australia wide (03)93709355
www.hearandlearn.com.au
www.hearandlearn.com.au
MICROPHONE TONE
MIN MAX TREBLE BASS
VOLUME
technology family.