Lightspeed Redcat Access LSRCA 1881 User Manual page 19

4. CHARGING THE FLEXMIKE
Before use, the Flexmike should be charged. It will take 8-9 hours for the Flexmike
to obtain a full charge. A fully charged Flexmike will last for up to 8 hours of use. If
microphones are used daily, they should be charged each night.
When properly inserted into a cradle charger, the Mic 1 or Mic 2 light will glow blue and
the red light on the Flexmike power button indicates the battery pack is charging. The
power button light will glow green to indicate that charging is complete and a full charge
has been reached.
Replacement NiMH battery packs may only be purchased through Lightspeed
Technologies (part # NH2.4V). Do not attempt to charge with other battery packs. They
can overheat and expand creating a significant hazard and damaging the microphone
(this is not covered by warranty).
1. Plug power cord into the cradle
charger and then plug the AC end
into an electrical outlet.
2. Place the Flexmike into the
cradle. (Figure 1) The LED on the
Flexmike power button will glow
red indicating charging has started.
The Mic 1 or Mic 2 light will glow
blue. (Figure 2)
3. Hang the Flexmike on the lanyard
opposite the magnetic clasp.
(Figure 3)
www.hearandlearn.com.au
Redcat Access is part of the
Offices Australia wide (03)93709355
Figure 1
Figure 2
Figure 3
www.hearandlearn.com.au technology family.
19