Redmike Share: Initial Set-Up - Lightspeed Redcat User Manual

REDMIKE SHARE: Initial Set-up

1. Ensure the Redcat is on. The blue LED
on the front panel will glow.
2. Turn on the Redmike Share by sliding
the switch to the top position.
3. Grip the barrel in the center section.
Avoid covering the infrared
emitters just below the microphone
grille. This could interrupt signal
transmission.
4. While speaking in a normal voice,
increase the channel B volume on
the Redcat until your voice is barely
audible.
REMEMBER: This equipment is designed
to supplement and distribute the user's
voice so they are able to speak in a
conversational tone. Having the volume
set too high will result in feedback and
listener fatigue.
24