Set Up 2-Wire Device Weather Sensors - Rain Bird ESP-LXIVM Series Installation, Programming & Operation Manual

Set Up 2-Wire Device Weather Sensors

Turn the dial to 2-Wire Settings
A
At the 2-WIRE SETUP screen, press the Down Arrow key to select
Weather Sensors, then press Next.
B
At the Weather Sensor Setup screen, press the + and – keys to
set the desired Weather Sensor (from 1-7), then press the Right
Arrow key.
A
2-WIRE SETUP
Master Valves
Weather Sensors
Station Setup
Flow Sensors
Advanced Station Settings
Next
27 ESP-LXIVM Series Controllers
B
Weather Sensor Setup
01 - - - - -
WS Address
C
Press the + and – keys to set the desired Sensor Address. Press the
Arrow keys to navigate between the number setting fields. Once
all fields are entered, press the Next key.
B
NOTE: An alarm will show if a duplicate 2-Wire Device address
is entered for more than one sensor. See "Alarms" on page 21
for more details.
D
Press the + and – keys to select the type of weather sensor (Rain,
Freeze, Wind, Soil Moisture, Custom Pause, or Custom Prevent),
then press the Down Arrow key to continue.
C
Weather Sensor Setup
01 1 0 0 0 1 1
WS Address
Next
E
Press the + and – keys to set the desired settling time.
E
Weather Sensor Setup
WS 1
Type: Rain
MM:SS
Settling Time:
00:30
Done
B
NOTE: Settling time is how long a weather condition must last
before the controller takes action. For example, if a freeze sen-
sor has a 5 minute settling time then the temperature would
have to remain below the sensor's threshold set point for 5
minutes before irrigation is paused. Settling time can be set for
immediate (0 seconds) or up to 10 minutes long.
H
Repeat this process to set up additional weather sensors. Be
sure to note each weather sensor on your Programming Guide
for future reference.
D
Weather Sensor Setup
WS 1
Type: Rain
MM:SS
Settling Time: 00:30
Done