Rain Bird ESP-LXIVM Series Installation, Programming & Operation Manual page 40

Turn the dial to 2-Wire Settings
A
At the Advanced Station Settings screen, press the Down Arrow
key to select 2-Wire Mapping, then press Next.
B
At the 2-Wire Device Mapping screen, press the + and – keys to
set the desired hour (from 0 to 23), then press the Right Arrow
key.
A
Advanced Station Settings
Cycle & Soak
Inter-Station Delay
SimulStations
Station Sequencing
2-Wire Mapping
Next
40 ESP-LXIVM Series Controllers
B
2-Wire Device Mapping
Start Device Mapping In
00 : 00
HH:MM
Next
C
Press the + and – keys to set the desired minute (from 1 to 59), then
press Next.
D
At the confirmation screen, press Start to begin Device Mapping.
B
NOTE: All irrigation is disrupted during the mapping process.
C
2-Wire Device Mapping
Start Device Mapping In
01 : 05
HH:MM
Next
E
A confirmation screen shows the process is set to run.
E
Mapping
Mapping will begin
In 1 Hrs and 5
Mins.
Cancel Done
D
Attention
Device Mapping will
interrupt all irrigation
and could take several
minutes
Start