Complete Installation; Programming Under Battery Power; Complete The Installation - Rain Bird ESP-LXIVM Series Installation, Programming & Operation Manual

Complete Installation

C CAUTION
To prevent electrical shock, make sure all supply power
is OFF before completing installation. Electrical shock can
cause severe injury or death.
A
If you removed the front panel, reinstall it now by inserting the
top corner pin into the top pin-hole, then push up and rock the
bottom corner pin into the lower pin-hole.
B
Reconnect the ribbon cable to the front panel by gently pushing
the connector into the socket.
NOTICE
Be careful NOT to bend the pins in the socket.
B
A
C
Turn on the power source.
B
NOTE: The fi rst time you power up the controller, the display
will prompt you to select the language you wish to use. See
"Language Select Button" on page 19 for more details.
115 ESP-LXIVM Series Controllers

Programming Under Battery Power

The ESP-LXIVM controller front panel can operate under battery
power for remote programming. This feature is especially useful if
the controller is installed in an area that is not easily accessible. It
also lets you enter program information before installing the con-
troller at the job site. All program information is stored in nonvolatile
memory so it will be preserved indefi nitely in the event of a power
outage.
B
NOTE: Under battery power, all programs in progress will con-
tinue to run in memory, but irrigation will not occur until power
is restored. Without battery power, remaining programs will be
cancelled.
A
Install a new 9-volt battery in the battery compartment in the
back of the front panel.
A
B
NOTE: To perform remote programming, detach the front panel
from the cabinet. See Access Controller Cabinet for more details.
NOTICE
The controller can not run irrigation or system diagnostics
with the front panel detached. Re-connect the front panel to
the controller's AC power source as soon as remote program-
ming is completed.