Setup - CYBEX Arc Trainer 626A Owner's Manual

2. Remove the nut at the end of the coax cable.
3. Insert the coax cable into the D-shaped hole in the mounting plate on the front of the unit.
4. Thread the nut removed in step 2 onto the coax cable.
5. Install the coax cable to the mounting plate on the front of the unit using a 14 mm open end wrench.
6. Plug the Ethernet or HDMI cable into the coupler on the front of the unit.
Visually inspect unit
1. Remove any packing material from unit.
2. Examine the unit to ensure that the assembly is correct and complete.

Setup

Use the following instructions to setup the unit.
1. Plug the optional power cord or E3 View Monitor power cord (E3 View Monitor units only) into a
power outlet from a grounded circuit.
Coil up the remainder of the power cord and place it out of the way. The control panel will light up
and be in the Dormant Mode.
2. Hold the handrails to steady self while stepping into the foot plates.
3. Begin striding.
Time and Date confirmation
The first time the unit is turned on, it prompts the user to confirm the current Time and Date. Quick Start,
Workouts, Setup or Stop will skip this requirement but it will appear again the next time the unit is
powered up until the time and date are properly set.
1.
Press the ENTER
(MM) and then AM/PM/24.
2.
Press the UP
Cybex 626A/626AT, 627A/627AT Arc Trainer Part Number 5626-4 J
key to begin editing the time, starting with the hours (HH) and then minutes
and DOWN keys to select the hour.
1
2
Page 41 of 83
Description
Coax cable
Nut
Qty.
1
1