Mitsubishi Electric MELSEC iQ-R Series User Manual page 19

Wave output mode
This operation mode is for performing the wave output. The value set in Wave data registry area (Un\G10000 to Un\G99999)
is continuously output in analog after sequent D/A conversion. Conversion speed is 20s/CH.
Wave data
Program
registry area
For details on the wave output function, refer to the following.
Page 45 Wave Output Function
Inter-module synchronization mode
The D/A conversion is performed at the inter-module synchronization cycle in this mode. The value set in 'CH1
Synchronization digital value' (Un\G9500) is output in analog after the D/A conversion.
CH
Program Synchronization
digital value
Offset/gain setting mode
The operation mode for the offset/gain setting
For details on the offset/gain setting, refer to the following.
 MELSEC iQ-R High Speed Digital-Analog Converter Module User's Manual (Startup)
Warning output
Check code result
function
Analog output
D/A conversion
HOLD/CLEAR
function
Warning output
Check code result
function
Analog output
D/A conversion
HOLD/CLEAR
function
Analog output
Analog output
1 FUNCTIONS
1.1 Modes
1
17