Mitsubishi Electric MELSEC iQ-R Series User Manual page 177

CH1 Output value during wave output stop
Wave
This area is for setting the value to be output in analog when 'CH1 Output setting during wave output stop' (Un\G524) is set to
Output value during wave output stop (2).
The setting range varies depending on the output range setting. Follow the setting range below.
Output range
0 to 5V
1 to 5V
0 to 20mA
4 to 20mA
-10 to 10V
• In the channel where a value out of the above setting range is set, a setting range error for Output value during wave output
stop (error code: 1D3H) occurs. The wave output does not start. However, when 'CH1 Output setting during wave output
stop' (Un\G524) is set to a value other than Output value during wave output stop (2), the above error does not occur.
• As the default value, 0 is set. Thus change the setting value for 'CH1 Output value during wave output stop' if 'CH1 Output
setting during wave output stop' (Un\G524) is set to Output value during wave output stop (2).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Output value during wave output stop
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is 0 for all channels.
Setting range
0 to 32767 (practical range: 0 to 32000)
-32768 to 32767 (practical range: -32000 to 32000)
CH1 CH2
525 725
CH3 CH4
925 1125
APPX
Appendix 3 Buffer Memory Areas
A
175