How Do I Set Up My Radar - Raymarine C-Series Reference Manual

Chapter 5: Using the Radar

5.11 How do I set up my radar?

The set up for your radar can be changed from the standard configuration to suit your
particular needs. Although you will probably only do this when you first use the radar,
you may decide to make subsequent adjustments once you become more familiar with
the system. Any settings that you change are retained and become the default settings
even when you power off.
To select the Radar Setup menus, press MENU when a radar window is active and then
select Radar Setup.
When a radar window is active, you can also access this menu by pressing the
Note:
TARGETS DISPLAY soft key and then pressing and holding the INT.REJECT, EXPAN-
SION OR WAKES key.
Function
Description
Interference Rejection
When Interference Rejection is switched ON, any mutual radar
interference between two radar equipped vessels operating within
range of each other, is automatically reduced.
Target Expansion
When Target Expansion is switched ON, targets are magnified to
make them easier to see.
Wakes Period
When wakes is switched ON, the target is displayed at the bright-
est level and its previous positions are retained at successively
fainter levels on the screen.
Timed Transmit
Controls the radar's timed transmission power-save mode
Transmit Period
When Timed Transmit set to ON, the scanner performs the number
of scans specified and then shuts down for the number of minutes
specified by the Standby Period.
Standby Period
Indicates the number of minutes that the system shuts down - the
scanner does not rotate and the display is in standby mode.
Bearing alignment
Corrects for display azimuth error.
Please refer to the C-Series Installation Guide.
Radar Advanced Setup
Please refer to the C-Series Installation Guide.
5-27
OPTIONS
(Default in bold)
NORMAL
HIGH
LOW
HIGH
10 seconds
30seconds
1 minute
5 minutes
10 minutes
OFF
ON
10 scans
20 scans
30 scans
3 minutes
5 minutes
10 minutes
15 minutes
OFF
ON