Related Manuals for Raymarine a9 Series
Summary of Contents for Raymarine a9 Series
- Page 1 a9x / a12x Mounting a nd Ge tting S ta rte d Da te : 05-2014 Docume nt numbe r: 88032-1-EN © 2014 Ra yma rine UK Limite d...
- Page 2 ENGLISH Document number: 88032-1 Date: 05-2014...
- Page 3 Contact your Raymarine dealer for further details, and the radar is transmitting. refer to the separate warranty document packed with your product.
- Page 4 Only official government charts and notices to • Raymarine equipment and cables connected to it are: • DO NOT use a metallic instrument such mariners contain all the current information needed...
- Page 5 This Class B digital apparatus complies with Canadian 1. This device may not cause harmful interference. ICES-003. Raymarine cables may be fitted with suppression ferrites. These are important for correct EMC 2. This device must accept any interference received, Industry Canada (Français) performance.
- Page 6 Declaration of conformity IMO and SOLAS Features • NMEA 0183 Raymarine UK Ltd. declares that this product is The equipment described within this document is • Bluetooth compliant with the essential requirements of R&TTE intended for use on leisure marine boats and workboats directive 1999/5/EC.
-
Page 7: Handbook Illustrations
Features • NMEA 0183 • Ensure that equipment is mounted in a compartment of suitable size. • Bluetooth • Ensure that ventilation holes are not obstructed. • Wi-Fi • Ensure adequate separation of equipment. • Internal GNSS (GPS / GLONASS) receiver Mounting surface requirements Ensure units are adequately supported on a secure •... - Page 8 As display contrast, color and night mode performance vessels it may not be possible to locate the display this are all affected by the viewing angle, Raymarine far away from a compass. In this situation, the following recommends you temporarily power up the display...
- Page 9 6. Ensure that the unit fits into the removed area and then file around the rough edge until smooth. 7. Drill 4 holes as indicated on the template to accept the securing screws. 8. Place the gasket onto the display unit and press firmly onto the flange.
-
Page 10: Power And Data Connection
a9x and a12x connections overview 1. Carefully lift one edge of the screen protection film, so that it is accessible for removing when unit The a9x and a12x variant MFDs include the following 2 2 2 installation is complete. connections. 2. -
Page 11: Grounding - Dedicated Drain Wire
Straight power R62379 a9x and a12x then please consult a Raymarine authorized dealer for support. and data cable (supplied with a9x Grounding — Dedicated drain wire Fuse and breaker rating... - Page 12 • A software update will be required to add support for Beidou once the system is available. Please Note: * Only applicable to products that include a D13019-1 check with your Raymarine dealer for further drain wire on the product’s power cable. 1. Vessel power supply positive (+) details.
-
Page 13: Nmea 0183 Connection
Note: Extending the cable length by more than the Note: For Port 1, both the input and output recommended maximum length will result in signal communicate at the same baud rate. For example, if degradation. you have one NMEA 0183 device connected to the display's Port 1 INPUT, and another NMEA 0183 device connected to the display's Port 1 OUTPUT, Connecting an external antenna... -
Page 14: Memory Cards And Chart Cards
When archiving data or creating an electronic chart 4. Open the card reader door. card, Raymarine recommends the use of quality branded memory cards. Some brands of memory card 5. Push the edge of the card towards the unit, until an Memory cards and chart cards may not work in your unit. -
Page 15: Adjusting The Display Brightness
The simulator mode is switched on / off in the System countdown reaches zero, the power off is cancelled. Setup Menu. Note: Raymarine recommends that you do NOT use the simulator mode whilst navigating. Adjusting the display brightness Note: The simulator will NOT display any real data, including any safety messages (such as those received from AIS units). -
Page 16: Series Controls
a Series Controls Screen Icon for a page featuring a single item Description application. Icon — each icon represents an application page. A page can display multiple applications simultaneously. Status bar — the status icons confirm the status of externally-connected equipment, including GPS, AIS, radar, sonar and autopilot units. - Page 17 Alarms Note: Raymarine strongly recommends that you Weather application — (North America familiarize yourself with touch operations while your only). With a suitable weather receiver Alarms alert you to a situation or hazard requiring your vessel is anchored or moored. You may find it connected to your system, the weather attention.
- Page 18 a9x / a12x...
- Page 20 www.ra ym a rin e .c o m...