Raymarine C-Series Reference Manual page 119

Chapter 5: Using the Radar 5-17
EBL
VRM
How do I create a VRM/EBL?
VRM/EBL
VRM/EBL 1 ADJUST VRM ADJUST EBL FLOATING SET UP
ON OFF 1.991nm 124ºP EBL... VRM/EBL 2
The first VRM/EBL will be placed at a location of 1/3 of the current range and 030°
relative to your boat's head. If this setting is adjusted, the display will retain the
adjustments and use them when the VRM/EBL is next turned on.
To use VRMs/EBLs to tell you the range/bearing of a target:
1. Toggle VRM/EBL soft key to ON. The VRM/EBL will be shown on the radar picture
with your boat at its center.
2. ADJUST VRM and VRM are highlighted to indicate it can be adjusted.
3. Use the rotary control to adjust the VRM to the required size.
4. Press OK to remove the highlight and retain the adjustment.
5. Press ADJUST EBL. This will highlight the EBL.
6. Use the rotary control to place the EBL over the required target.
7. Press OK to remove the highlight and retain the adjustment.
You can also push the rotary control to accept an adjustment and toggle control
Note:
to the other object (VRM or EBL).