Raymarine C-Series Reference Manual page 122

5-20
Sector guard zone
6nm Head-Up
To set up a sector guard zone:
ZONE SHAPE
SECTOR
1. Toggle ZONE SHAPE to SECTOR.
2. Press SET INNER to highlight the soft key label. The inner limit is highlighted.
3. Use the rotary control to set the inner limit of the guard zone..
4. Press OK to accept the adjustment.
5. Repeat steps 2 to 4 for the SET OUTER, SET WIDTH and SET AZIMUTH (in relation ot
the SHM) limits for this guard zone.
You can also push the rotary control to accept an adjustment. Doing this also
Note:
toggles control to the next setting.
Relative Motion
SET INNER
CIRCLE xx.xx nm
C-Series Display Reference Manual
Rings 1nm
SET OUTER SET WIDTH
xx.xx nm xx
Sector
Guard Zone
SET BEARING
xxx