Raymarine C-Series Reference Manual page 87

Chapter 4: Using the Chart
• An existing waypoint for inclusion in your route. The soft key USE THIS WAY-
POINT is displayed or:
• The position for a new waypoint. The soft key PLACE WAYPOINT is displayed.
4nm
4. Press PLACE WAYPOINT or USE THIS WAYPOINT.
The new leg is incorporated into the route. The dashed line changes to a solid line
and the route index re-numbers accordingly.
... by adding a waypoint(s) to the end of your route
1. Select the appropriate route for editing via the REVIEW AND EDIT ROUTES soft key
or select the route on screen and then press REVIEW AND EDIT THIS ROUTE.
2. Press AMEND ROUTE COURSE.
Your cursor is joined to the last waypoint in the route with a dashed line.
3. Either drag the cursor to select:
• An existing waypoint. The soft key USE THIS WAYPOINT is displayed.
Or:
• The position where you want a new waypoint to be placed. The soft key PLACE
WAYPOINT is displayed.
4. Press USE THIS WAYPOINT or PLACE WAYPOINT.
The dashed line changes to a solid line to indicate that the new leg has been added
to the end of your route.
5. If required, you can add further waypoints to the end of the route by repeating
steps (3) and (4) above.
North-Up (Relative Motion)
RTE
PLACE WAYPOINT
Original Position Amended
course for new route
waypoint
4-25
Local