Using The Radar With The Chart; Synchronizing The Chart With Radar Range; Viewing Marpa Targets On The Chart - Raymarine E Series Reference Manual

81244_4.book Page 90 Thursday, January 31, 2008 1:53 PM
90
Note:

4.14 Using the radar with the chart

You can enhance the use of your chart by combining it with the following radar
features:
• Radar range synchronization
• MARPA.
• Radar overlay.

Synchronizing the chart with radar range

When synchronization is switched on:
• The radar range in all radar windows, changes to match the chart scale.
• 'Sync' is indicated in the top left-hand corner of the chart window.
• If you change the radar range, in any radar window, all synchronized chart views
change scale to match.
• If you change the scale of a synchronized chart window, all radar windows change
range to match.
To set the radar range synchronization:
Notes: (1)

Viewing MARPA targets on the chart

The Mini Automatic Radar Plotting Aid (MARPA) function is used for target tracking
and risk analysis. Although set up in radar mode or radar overlay, all MARPA targets
Setup
Chart Setup...
MENU
Cartography Setup
GPS Status...
Compass Setup...
System Setup...
Alarm Setup...
Select Alarm Setup
For more details of alarms, see page 289.
CHART MODE AND
PRESENTATION...
ORIENTATION...
Radar range synchronization is not available when the chart motion
mode is set to Autorange.
The 2D chart can be synchronized with either the 3D chart (see page 125)
(2)
or the radar but not both.
If you have a digital radar set to dual range connected to your system then
(3)
Chart-Radar sync is temporarily disabled, to re-enable Chart-Radar sync
mode, disable Dual Range mode.
E-Series Networked Display Reference Manual
Alarm Setup Menu
System Alarms Setup...
Navigation Alarms Setup...
Radar Alarms Setup...
Fishfinder Alarms Setup...
Select appropriate sub-menu
CHART SYNC
RDR