How Do I Erase A Waypoint; How Do I Change The Default Symbol And Group - Raymarine C-Series Reference Manual

3-8
...by dragging the waypoint to a new position
You can drag a waypoint to a new position using the cursor and trackpad:
1. Use the cursor to select the waypoint that you want to move.
2. Press MOVE WAYPOINT.
3. Use the trackpad to drag the waypoint to the new location.
4. Press OK to save or CANCEL to abandon the move
CAUTION:
It is possible to move waypoints that are used in routes. In such instances, the
stored route will include the Waypoint in its new position. Ensure that this
does not present a navigation hazard.

How do I erase a waypoint?

You can erase any waypoint on the system using the cursor or the waypoint list
except:
• The waypoint that you are currently navigating to (See
cific point?
• Any waypoint used in a route.
If you attempt to erase such a waypoint, a warning message will be displayed
...using the cursor
1. Move the cursor over the waypoint that you want to erase.
2. Press ERASE WAYPOINT.
3. You will then be asked to confirm this. Press YES to confirm, or NO to cancel.
...using the waypoint list
1. Select the waypoint in the waypoint list.
2. Press ERASE WAYPOINT.
3. You will then be asked to confirm this. Press YES to confirm, or NO to cancel.

How do I change the default symbol and group?

When you add a waypoint to your system it is assigned to the default group and given
the default symbol:
Default Symbol
Default Group
If these are not suitable, you can select an alternative symbol and group to be the
default:
page 4-7 or
on ),
C-Series Display Reference Manual
How do I navigate to a spe-