Programme End; Switching Off The Appliance; Interrupting The Programme; Terminating The Programme - Siemens SN Series Instruction Manual

Keep pressing the setting buttons + -
5.
` until the displayed time
corresponds with your requirements.
Press START button )2, timer
6.
programming is activated.
To delete the time preselection,
7.
press START button )2 for approx.
3 seconds.
Time preselection was terminated.
Close the door.
8.

Programme end

* The programme has ended when
"Finished" is indicated on the display
window at the top @ and on the front
display * ):.
* The end of the programme is
displayed on the floor – provided the
TimeLight (optical display) is switched
on and is visible.
* depending on the features of your
dishwasher

Switching off the appliance

Short time after the end of the
programme:
Open the door.
1.
Switch off ON/OFF switch (.
2.
Turn off tap (does not apply to
3.
appliances with Aqua-Stop).
Remove the utensils when they have
4.
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
Cleaning and maintenance en
connection or is heated, always leave
the door ajar for several minutes and
then close.
Open the door.
1.
Switch off ON/OFF switch (.
2.
The LEDs go out. The programme
is saved.
To continue the programme, switch
3.
on the ON/OFF switch ( again.
Close the door.
4.

Terminating the programme

(Reset)
Open the door.
1 .
T e r m i n a t i n g t h e p r o g r a m m e
Press the START button )2 and
2.
hold for 3 seconds
The display window at the top @
and the front display * ): show:
"Program was terminated".
Close the door.
3.
The programme sequence lasts
approx. 1 min. The display window
at the top @ shows: "Finished".
Open the door.
4.
Switch off ON/OFF switch (.
5.
Close the door.
6.
* depending on the features of your
dishwasher

Changing the programme

When the START button )2 has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
2
Cleaning and
maintenance
A regular inspection and maintenance
C l e a n i n g a n d m a i n t e n a n c e
of your machine will help to prevent
35