Siemens SN Series Instruction Manual page 43

Fault
Food remnants on the
utensils.
* depending on the configuration of your specific dishwasher
Reason
Utensils placed too closely
together, utensils basket
overfilled.
Spray arm rotation obstructed.
Spray arm nozzles are blocked.
Filters 1j dirty.
Filters 1j inserted incorrectly
and/or not engaged.
Wash programme too weak.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Top basket 12 on right and left
not set to same height.
Fault, what to do? en
Remedial action
Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Arrange utensils so that the spray arm can
rotate without obstruction.
Clean the spray arm nozzles.
~ "Cleaning and maintenance"
on page 35
Clean filters. ~ "Cleaning and
maintenance" on page 35
Insert and engage filters correctly.
Select a more intensive wash programme.
Increase sensitivity of the sensors.
~ "Sensor setting" on page 32
Do not prerinse utensils. Remove only
large food remnants.
Increase sensitivity of the sensors.
~ "Sensor setting" on page 32
Recommended programme Eco 50° or
Intensive.
Do not place hollow receptacles too
obliquely and do not place in the corner
area.
Set top basket to same height using side
levers.
43