Safety instructions Delivery Ensure that the protective conductor system 1. Check the packaging and of the domestic supply has dishwasher immediately for been correctly installed. damage caused in transit. Do The electrical connection not switch on a damaged conditions must correspond appliance, but contact your with the specifications supplier.
Safety instructions After installing the appliance, If the fascia is damaged ensure that the plug is easily (cracks, holes, broken accessible. buttons), do not operate the appliance. Pull out the mains (See Electrical connection) plug or switch off the fuse. Some models: Turn off the tap, call The plastic housing on the...
Safety instructions If the appliance Keep children away from is not in a cavity and a side detergents and rinse aid. panel is accessible, the door These may cause chemical hinge area must be covered burns in the mouth, throat at the side and eyes or asphyxiation.
Water softening system/Special salt Appliance interior Setting The amount of salt dispensed can be 1" Top basket set in 4 stages 1* Knife shelf * depending on the hardness of your 12 Tablet collecting tray water. Accordingly 0, 1, 2 or 3 displays are lit (see table).
Water softening system/Special salt Water hardness table &ODUNH +DUGQHVV PPROO UDQJH & 6HWWLQJ VRIW PHGLXP KDUG KDUG Using special salt Using detergents with salt component D e t e r g e n t s wi t h s a l t co m p o n e n t Always refill with special salt...
Rinse aid 3. Close cover until it clicks shut. Rinse aid 4. To prevent excessive foam formation a i d R i n s e during the next rinse cycle, remove any rinse aid which has run over with As soon as the rinse-aid refill indicator )"...
Utensils Switching off rinse-aid refill Recommendation: indicator Use only glasses and porcelain which the manufacturer designates as dishwasher-proof. If the rinse-aid refill indicator )" is Use a detergent which protects impaired (e.g. when using combined utensils. detergents containing rinse-aid component), it can be switched off. Take glass and cutlery out of the dishwasher as soon as possible after Proceed as described under “Setting...
Utensils Cups and glasses Other examples, such as the best way Top basket 1" of loading your dishwasher, can be found on our homepage as a free download. The corresponding Internet address can be found on the back page of these instructions for use. Cutlery basket You should always place cutlery unsorted with the points downwards.
Utensils Small accessories holder * A djusting the height of the Sm a l l ac c e s s o r i e s ho l d e r Ad j u s t i n g t h e h e i g h t o f t h e b a s k e t basket * * depending on model Light-weight plastic accessories, e.g.
Detergent 3. To raise the basket, hold the basket Detergent on the sides of the upper edge and lift it up. D e t e r g e n t 4. Before re-inserting the basket again, You can use tablets as well as powder ensure that it is at the same height or liquid detergents for dishwashers, but on both sides.
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 9" is still slightly less than the indicated amount closed, press the lock 9* to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 9"...
Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options · Information for test institutes Hygiene * Hy g i e n e Test institutes receive the information for The temperature is increased during the comparability tests (e.g. according to cleaning process. This increases the EN60436). hygiene status. This additional option is ideal for cleaning e.g.
Operating the appliance 4. Press the START button h. Operating 5. Close the door. the appliance The programme starts running. a n c e a p p l i n g t h e O p e r a t i Note Programme data - for environmentally friendly operation...
Operating the appliance End of programme Interrupting the programme The programme has ended when 1. Open the door. neither of the two displays ` or X 2. Switch off ON/OFF switch (. is lit. The LEDs go out. The programme is The end of the programme is also saved.
Cleaning and maintenance Intensive drying Overall condition of the machine The final rinse uses a higher temperature which improves the drying Check spray arm for grease result. The running time may increase and limescale deposits. slightly. (Caution if utensils are delicate!) If you find such deposits: 1.
Cleaning and maintenance Filters Spray arms The filters 1R keep large foreign Limescale objects in the rinsing water away from and contaminants in the rinsing water the pump. These foreign objects may may block nozzles and bearings on the spray arms 1: occasionally block the filters.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display )2 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min.
Fault, what to do? Fault Cause Remedial action Refill indicator for salt )* No rinse aid. Refill rinse aid. and/or rinse-aid )" is lit. No salt. Refill with special salt. Sensor does not detect salt Use different special salt. tablets. Refill indicator for salt )* Refill indicator switched off.
Fault, what to do? Fault Cause Remedial action Appliance interior wet after No appliance fault. On account of the “Condensation drying” rinse cycle. principle, water droplets are physically induced and required in the container. The humidity in the air condenses on the inner walls of the dishwasher, drains and is pumped out.
Fault, what to do? Fault Cause Remedial action Detergent residue Detergent dispenser cover Detergent dispenser cover must not be blocked by utensils and therefore obstructed by utensils. does not open fully. Do not place utensils or fragrance dispenser in the tablet collecting tray. Detergent dispenser cover Tablet must be inserted flat and not upright.
Fault, what to do? Fault Cause Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according water hardness greater than to instructions for use or top up salt.
Fault, what to do? Fault Cause Remedial action Removable streaks on Too much rinse aid. Set rinse aid amount to lower setting. glasses, glasses with No rinse aid added or setting too Add rinse aid and check dosage metallic appearance and low.
Fault, what to do? Fault Cause Remedial action The door is difficult Child-proof lock is activated. Deactivate childproof lock. (See instructions to open. for use at the back) Door cannot be closed. Door lock has been activated. Close door with increased force. Door cannot be closed due to Check appliance installation: Door or installation.
Customer service Customer service Installation and connection e r v i c e C u s t o m e r s If you are unable to rectify the fault, i o n a n d c o n n e c t l a t i o n I n s t a l please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Water pressure: The connection may be modified by technicians only. at least 0.05 MPa (0.5 bar), maximum A power cord extension may be 1 MPa (10 bar). At a higher water purchased from customer service pressure: connect pressure-reducing only.
Installation and connection Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: 1. Turn on the tap. 2. Open the door. 3. Switch on ON/OFF switch (. 4. Select programme @ with the highest temperature button < 5.