Hygieneplus (Hygieneplus); Intensivezone; Extradry; Shine And Dry - Siemens SN Series Instruction Manual

detergent in the detergent dispenser
than for a full load.
μ
HygienePlus
(HygienePlus) *
T his function increases the
H y g i e n e P l u s ( H y g i e n e P l u s )
temperatures and maintains them for an
extra-long time to ensure a defined
disinfection performance. This slightly
increases energy consumption and the
run time.Continuous use of this function
improves the hygiene status. This
additional option is ideal for cleaning
e.g. chopping boards and baby bottles.
Ï

IntensiveZone *

P erfect for mixed loads. You can wash
I n t e n s i v e Z o n e
very soiled pots and pans in the lower
basket together with normally soiled
tableware in the upper basket. The
spray pressure in the lower basket is
intensified. This will increase the run
time and the energy consumption then
rises.
¿

ExtraDry *

A higher temperature during the final
E x t r a D r y
rinse and an extended drying phase
ensure that plastic parts will also dry
better. This slightly increases energy
consumption. The run time will be
extended.
ï

Shine and Dry *

B y increasing the amount of water
S h i n e a n d D r y
during the rinse cycle and extending the
drying phase, stains are prevented and
the drying result is improved. There is a
slight increase in the energy
consumption. Rinse aid is
recommended for the high gloss drying
function (even when using combination
detergents).
Operating the appliance en
ß

Energy Save *

T he "Energy Save" function can be
E n e r g y S a v e
used to reduce water and energy
consumption. The running time
is extended for optimum cleaning and
drying results.
1
Operating the
appliance
P rogramme data
O p e r a t i n g t h e a p p l i a n c e
The programme data (consumption
values) can be found in the summary
of instructions. They refer to normal
conditions and the water hardness set
value °E 16 - 20 medium. Different
influencing factors such as water
temperature or line pressure may result
in deviations.

Changing the settings

The dishwasher has been preset with
certain settings for your convenience.
You can change these factory settings.
Change the setting as follows:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button {8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button >)R until the
4.
required setting is indicated on the
display window at the top @.
Make the setting with setting buttons
5.
+ -`.
Press and hold the Info button {
6.
8 for 3 seconds.
31