Fault Table - Siemens SN Series Instruction Manual
Hide thumbs
Also See for SN Series:
- Instruction manual (56 pages) ,
- Operating instructions manual (46 pages) ,
- Operating insructions (38 pages)
Advertisement
Table of Contents
Scoop out water, use a sponge if
4.
required.
Prise off the pump cover (as shown)
5.
using a spoon. Grip the pump cover
by the crosspiece and lift diagonally
inwards (1). Remove cover
completely.
Fault table
Fault
Fault code ":‚‰ is lit.
* depending on the configuration of your specific dishwasher
Reason
Supply hose kinked.
Water supply turned off.
Water supply jammed or
calcified.
Filter in the water supply blocked. Switch off the appliance and pull out the
Check impeller wheel and remove
6.
any foreign objects.
Place pump cover in the original
7.
position (2) and press down until it
engages (3).
Install filters.
8.
Re-insert baskets.
9.
Remedial action
Install supply hose without kinks.
Turn on water supply.
Turn on water supply.
Flow rate must be at least 10 l/min. when
water supply is open.
mains plug. Turn off water supply.
Unscrew water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Fault, what to do? en
39
Advertisement
Table of Contents
