Table of Contents
Advertisement
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P until the digital
display H jumps to :
4. Press button P until the displayed
time corresponds with your
requirements.
5. Press START button @, timer
programming is activated.
6. To delete the preselected starting
time, press the button P until
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value :
is indicated on the numerical
display H.
Switching off automatically
after the end of
the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
.
can be adjusted from :
:
:
:
1. Close the door.
2. Switch on ON/OFF switch (.
is
3. Press and hold down the START
4. Rotate programme selector 8
5. Release button.
To change the setting:
1. Rotate programme selector 8 until
2. Press START button @.
Operating the appliance
Appliance does not switch off
automatically
Off after 1 min
Off after 120 min
button @.
until : ... s indicated on the digital
display H.
The factory set value :
the digital display H.
the required value is indicated on the
digital display H.
The set value is saved.
en
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
to :
.
is lit on
23
Advertisement
Table of Contents
