Spray Arms; Fault, What To Do; Error Message; Waste Water Pump - Siemens SN Series Instruction Manual

en Fault, what to do?

Spray arms

Limescale and contaminants in the
rinsing water may block nozzles and
bearings on the spray arms 1: and
1Z.
Check outlet nozzles on the spray
1.
arms for blockages.
Unscrew the upper spray arm 1:
2.
(1) and remove downwards (2).
Remove the lower spray arm 1Z
3.
upwards.
Clean spray arms under running
4.
water.
Re-engage or screw on spray arms.
5.
3

Fault, what to do?

E xperience has shown that you can
F a u l t , w h a t t o d o ?
rectify most faults which occur in daily
operation yourself. This ensures that the
appliance is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
38
Note: If the appliance stops during
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset)
~ "Operating the appliance"
on page 31.
:
Warning
Improper
repairs or use of non-original spare
parts may cause considerable damage
and put the user at considerable risk!
Always have repairs carried out by
technicians. If a component has to be
replaced, always use original spare
parts.

Error message

Some faults are indicated at the top of
the display window @ and on the front
display * ): and possible remedies
are offered (for example Filter system
soiled (E22) -->Clean filters).
* depending on the features of your
dishwasher

Waste water pump

Large food remnants or foreign objects
which were not captured by the filters
may block the waste water pump. The
rinsing water will then be above the
filter.
:
Warning
Danger of cutting!
Sharp and pointed objects or glass
fragments may block the waste water
pump.
Always carefully remove foreign objects.
Clean the waste water pump as
follows:
Disconnect the dishwasher from the
1.
power supply.
Take out top basket 12 and bottom
2.
basket 9*.
Remove the filters 1j.
3.