Settings - Siemens SN Series Instruction Manual
Hide thumbs
Also See for SN Series:
- Instruction manual (56 pages) ,
- Operating instructions manual (46 pages) ,
- Operating insructions (38 pages)
Advertisement
Table of Contents
en Getting to know your appliance
Initial start-up settings
Time setting
Water hardness
Rinse aid disp.
Water connection *
* depending on the features of your dishwasher
--------
Settings
The dishwasher has been preset with
certain settings for your convenience.
However you can also change this
factory setting.
To change the setting:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button { 8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @
Scroll with < >
Set with - +
Leave with Setup 3 sec.
.
Basic setting
Time setting
Time format
Time display
Sprache/Language
Water hardness
* depending on the configuration of your specific dishwasher
12
Factory setting
12:00
°E 16 - 20 medium
Level 5
Cold water
Factory setting
12:00
24h
Time
Deutsch
°E 16 - 20 medium
Infotext
by pressing Info button {
Set the current time.
Adjustment to the local water hardness.
When using Multitabs, select the lowest
setting.
Amount of rinse aid affects drying. When
using Multitabs, select setting 0.
Connection to hot water (40-60°C) or cold
water (<40°C) possible.
Keep pressing button > )R until the
4.
required setting is displayed.
Make the setting with setting buttons
+ - `.
Press and hold the Info button {
5.
8 for 3 seconds.
The chosen setting has now been
stored.
You have the option of resetting all
changed settings back to the original
factory settings.
Note: When you reset your dishwasher
to the factory settings, you are taken
directly to the settings for the initial
start-up.
Infotext;
by pressing Info button {
Set the current time.
12h or 24h.
Show end of programme with display
"Ready in" or "Finish at".
Language selection.
Setting water hardness. When using
Multitabs, select the lowest setting.
Advertisement
Table of Contents
