Special Salt And Rinse Aid; Filters - Siemens SN Series Instruction Manual

particular commercial or industrial
cleaning agents, do not put aluminium
parts in the dishwasher. Danger of
explosion.
Notes
Remove any coarse soiling in the
■
interior using a damp cloth.
Clean the filters. ~ "Filters"
■
on page 37
Run the programme without dishes,
■
and in combination with a machine
cleaning detergent.
Use a special machine cleaning
■
detergent, and not dishwasher
detergent.
Observe the safety instructions and
■
the instructions for use on the
machine cleaning detergent
packaging.
*After three rinse cycles, the display
■
in the control panel will go out
automatically, even if you have not
run the Machine cleaning cycle
programme.
* depending on the features of your
dishwasher

Special salt and rinse aid

Top up the salt and/or rinse aid as soon
as the refill indicators on the fascia P
and H are lit or there is a prompt on
the front display * ):. Always top up
the special salt immediately before
switching on the dishwasher. This
ensures that overrun special salt
solution is immediately rinsed out and
that corrosion in the washing tank
cannot occur.
* depending on the features of your
dishwasher

Filters

The filters 1j keep large foreign
objects in the rinsing water away from
the pump. hese foreign objects may
occasionally block the filters.
Cleaning and maintenance en
The filter system consists of
a coarse filter
■
a flat fine filter
■
a microfilter
■
After each washing cycle check
1.
the filters for residue.
Unscrew filter cylinder as illustrated
2.
and take out filter system.
Remove the micro filter (1).
3.
Press together the locking catches
(2) and remove the coarse filter (3).
Remove any residue and clean
4.
filters under running water.
Re-install filter system in reverse
5.
sequence and ensure that the arrow
marks are opposite each other after
closing the filter system.
37