Detergents With Salt Replacement; Substances; Switching Off Water Softening System; Rinse Aid - Siemens SN Series Instruction Manual

en Rinse aid
Using detergents with salt
replacement substances
A ccording to the manufacturers,
D e t e r g e n t s w i t h s a l t r e p l a c e m e n t s u b s t a n c e s

detergents with salt replacement

substances can only be used up to a
specific degree of hardness (usually
21° dH, 37° fH, 26° Clarke,
3.7 mmol/l) if no special salt is added.
For optimum cleaning and drying
results, we recommend using special
salt from a water hardness of 14° dH
(25° fH, 17° Clarke, 2.5 mmol/l).
Switching off low salt
indicator / water softening
system
I f the use of combined detergents with
S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m
a salt component impairs the low salt
indicator P on the control panel or
the text on the display window at the
top @ (enough salt for x rinse cycles),
the displays can be switched off.
Proceed as described under "Setting
water softening system" and set the
value to 0-8. The water softening system
and salt refill indicator are now switched
off.
,

Rinse aid

As soon as the low rinse-aid indicator
R i n s e a i d
H is lit on the control panel or is
requested on the front display * ):,
rinse-aid should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
The function of rinse-aid is limited in
combination products. You will
generally obtain better results by using
rinse-aid.
* depending on the features of your
dishwasher
20
Top up the rinse-aid as follows:
Open dispenser 92; press lug on
1.
the lid (1) and lift (2).
Add rinse-aid up to the max. mark.
2.
Close the lid.
3.
Lid "clicks" into position.
Remove overflowed rinse aid with a
4.
cloth.
This prevents excessive frothing
during the next rinse cycle.

Setting amount of rinse aid

The amount of rinse aid to be
dispensed can be set from 0 to 6. Set
the amount of rinse aid to be dispensed
to 5 to obtain a very good drying result.
Do not change the amount of rinse aid
unless there are streaks or water stains
on the utensils. Set a lower level to
avoid streaks. Set a higher level to
avoid water stains.
Set the amount of rinse aid as follows:
Open the door.
1.