Rsb Clamp And Straight Shank Assembly - Landoll Brillion Zone Commander 2511 Operator's Manual

ASSEMBLY INSTRUCTIONS
RSB Clamp and Straight Shank
Assembly
1. The rigid clamp assemblies are already located on
the frame at the proper spacing.
2. Attach wearstrip to straight leg shank using wearstrip
bracket, 3/4-10 x 3 hex head cap screw, and 3/4-10
hex lock nut (See Figures 3-5 thru 3-7.)
3-6
Figure 3-5: RSB Clamp and Straight Leg Shank Assembly
3. Attach steel point to low disturbance straight leg
shank using 1/2 x 2 and 5/16 x 2 spring slotted pins.
Place pins with open ends oriented opposite of each
other.
4. Attach top of shank point assembly to front of spring
clamp assembly using 3/4-10 x 4 hex head cap screw
and hex lock nut. Attach lower hole of shank point
assembly to rear of spring clamp assembly using
5/8-11 x 5-1/2 hex head cap screw, connex bushing,
and 5/8-11 hex lock nut.
F-758R0