Spring Clamp Shank Assembly; Rigid Clamp Shank Assembly - Landoll Brillion CPP7 Operator's Manual

Spring Clamp Shank Assembly

Remove the 3/4-10 U-Bolts, Lockwashers and Nuts.
Place Shank Assembly Clamp under the frame and
re-insert the U-Bolts over the top of the frame and
through the Shank Assembly Clamp. Secure with
Lockwasher and Nut. See Figure 2-12.
Figure 2-12: Spring Clamp Shank Assembly
Check the tension on the Shank Spring. For normal
operation the Lock Nuts on the Spring mounting should
be tightened so that one inch of thread is exposed. See
Figure 2-13.
Figure 2-13: Spring Tension

Rigid Clamp Shank Assembly

Remove the front 3/4-10 x 7-1/2 Bolt, Lockwasher and
Nut and loosen the 5/8-11 Nuts so that they are flush with
the end of the Bolt. Slide the Shank Assembly onto the
Frame Tube until the Shank Support seats on the bottom
of the Frame Tube. Re-insert the 3/4-10 x 7-1/2 Bolt,
Lockwasher and Nut and tighten the 5/8-11 Nuts. See
Figure 2-14.
Figure 2-14: Rigid Clamp Shank Assembly
ASSEMBLY
2-13