Table of Contents
Advertisement
3-3 FRAME ASSEMBLY - WING MODELS
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
3-3.1
Bolt main frame halves together using
5/8-11 x 2 hex head cap screws and hex
lock nuts. (See Figure 3-3).
3-3.2
Attach SMV mounting bracket and warn-
ing light bar to rear frame near the center us-
ing 1/2-13 x 5-1/2 hex head cap screw and
hex lock nuts (See Figure 3-3).
3-3.3
Attach SMV emblem to SMV mounting
bracket using 1/4-20 x 1 hex head cap
screws and hex lock nuts.
3-4 SHANK, CLAMP, AND SWEEP ASSEMBLY
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
3-4.1
Center Clamp Assembly:
a. Attach center shank to center shank mount-
ing plate using 1/2-13 x 2 hex head cap screw
and hex lock nut (See Figure 3-5). Install
center shank mount assembly to frame using
center mounting bracket, 5/8-11 x 6-1/2 hex
head cap screws and hex lock nuts (See Fig-
ures 2-1 through 2-7 for location on frame).
3-3.4
Connect wings to frame using hinge pin,
1" flat washers, and 1/4 x 2 cotter pins (See
Figure 3-4).
3-3.5
Place frame and wing assembly on
stands approximately 36" high.
3-3.6
Install mast to frame using coulter sup-
port bars, 5/8-11 x 6 hex head cap screws,
and hex lock nuts.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.
b. Install danish sweep to center shank as-
sembly using 3/8-16 x 1-1/2 plow bolt and hex
lock nut.
3-4.2
Spring Clamp Assembly:
a. Slide shank into spring clamp assembly and
fasten tight using 5/8-11 x 1-3/4 round head
square neck screw and hex lock nut (See
Figure 3-5).
b. Install sweep to shank using 7/16-14 x 1-1/2
plow bolts, flat washers, split lock washers,
and hex nuts.
c. Recheck all bolts to be sure they are
torqued to proper specifications, inspect all
pivot points to insure they are snug, but not
binding. Grease all fittings.
3-7
Advertisement
Table of Contents
