Frame Assembly - Wing Models; Shank, Clamp, And Sweep Assembly - Landoll Tilloll 875 Series Operator's Manual

Frame Assembly - Wing Models

IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Bolt main frame halves together using 5/8-11 x 2 hex
head cap screws and hex lock nuts (See Figure 3-3.)
2. Attach SMV mounting bracket and warning light bar
to rear frame near the center using 1/2-13 x 5-1/2
hex head cap screw and hex lock nuts.
3. Attach SMV emblem to SMV mounting bracket using
1/4-20 x 1 hex head cap screws and hex lock nuts.
4. Connect wings to frame using hinge pin, 1" flat
washers, and 1/4 x 2 cotter pins (See Figure 3-4.)
5. Place frame and wing assembly on stands
approximately 36" high.
6. Install mast to frame using coulter support bars,
5/8-11 x 6 hex head cap screws, and hex lock nuts.

Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
WARNING
ASSEMBLY INSTRUCTIONS
Shank, Clamp, and Sweep
Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Center Clamp Assembly:
a. Attach center shank to center shank mounting
plate using 1/2-13 x 2 hex head cap screw and
hex lock nut (See Figure 3-5.) Install center
shank mount assembly to frame using center
mounting bracket, 5/8-11 x 6-1/2 hex head cap
screws and hex lock nuts (See Figures 2-1
through 2-7 for location on frame).
b. Install danish sweep to center shank assembly
using 3/8-16 x 1-1/2 plow bolt and hex lock nut.
2. Spring Clamp Assembly:
a. Slide shank into spring clamp assembly and
fasten tight using 5/8-11 x 1-3/4 round head
square neck screw and hex lock nut (See
Figure 3-5.)
b. Install sweep to shank using 7/16-14 x 1-1/2 plow
bolts, flat washers, split lock washers, and hex
nuts.
c. Recheck all bolts to be sure they are torqued to
proper specifications, inspect all pivot points to
insure they are snug, but not binding. Grease all
fittings.
3-7