Shank, Clamp, And Sweep Assembly; Gauge Wheel Installation - Landoll 876 Series Operator's Manual

3-2 SHANK, CLAMP, AND SWEEP ASSEMBLY

IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
IMPORTANT
SEE FIGURE 3-4 FOR PART NAMES.
3-2.1 Attach center shank to center shank
mounting plate using 1/2-13 x 2 hex head
cap screw and hex lock nut. Install center
shank mount assembly to frame using center
mounting bracket, 5/8-11 x 6-1/2 hex head
cap screws and hex lock nuts (See Figures
2-1 through 2-6 for location on frame).

3-3 GAUGE WHEEL INSTALLATION

3-3.1 All gauge wheel arms, rockshafts, and
hubs come already assembled from the fac-
tory.
3-2.2 Install danish sweep to center shank as-
sembly using 3/8-16 x 1-1/2 plow bolt and
hex lock nut.
3-2.3 Install shanks in clamps.
a. Spring clamp assembly - Slide shank into
spring clamp assembly and fasten tight using
5/8-11 x 1-3/4 round head square neck screw
and hex lock nut (See Figure 3-4).
b. C-clamp assembly - Slide shank into c-
clamp assembly and fasten tight using 5/8-11
x 2 round head cap screw and flange lock nut
(See Figure 3-4).
3-2.4 Install sweep to shank using 7/16-14 x
1-1/2 plow bolts, flat washers, split lock
washers, and hex nuts.
3-2.5 Recheck all bolts to be sure they are
torqued to proper specifications, inspect all
pivot points to insure they are snug, but not
binding. Grease all fittings.
3-3.2 Mount the tires on the wheels and in-
stall on the hubs.
Recommended tires:
11L X 15 18 ply Main Frame
11L X 15 10 ply Wings
3-7