Shank, Clamp, And Sweep Assembly - Landoll Tilloll 877 Operator's Manual

ASSEMBLY INSTRUCTIONS
Shank, Clamp, and Sweep
Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Attach center shank to center shank mounting plate
using 1/2-13 x 2 hex head cap screw and 1/2 lock nut
See Figures 3-8.
2. Install center shank mount assembly to frame using
top mounting bracket, flow divider valve bracket,
5/8-11 x 6-1/2 hex head cap screws, and hex lock
nuts See Figures 2-10
frame.
3. Install danish sweep to center shank assembly using
3/8-16 x 1-1/2 plow bolt and hex lock nut.
3-12
through for location on
2-12
4. Install shanks in spring shank assembly. Slide shank
into spring clamp assembly and fasten tight using
5/8-11 x 1-3/4 round head square neck screw and
5/8-11 flange head lock nut
5. Install sweep to shank using 7/16-14 x 1-1/2 plow
bolts, flat washers, split lock washers, and hex nuts.
6. Recheck all bolts to be sure they are torqued to
proper specifications, inspect all pivot points to insure
they are snug, but not binding. Grease all fittings.
See Figures 3-8.
F-1072-0320