Emerson Rosemount 3051 Reference Manual page 91

Reference Manual
00809-0100-4007
3. Follow the commands provided by the Field Communicator to complete the
4. Repeat the procedure for the upper value, replacing Lower Sensor Trim with Upper
Perform a sensor trim with AMS Device Manager
To calibrate the sensor with AMS Device Manager, complete the following steps:
Procedure
1. Right-click the device. Under the Method drop down menu, move cursor over
2. Follow the screen prompts to perform a sensor trim using AMS Device Manager.
3. If desired, right-click the device again. Under the Method drop down menu, move
Perform a sensor trim using LOI
Reference
Figure 5-2: Sensor Trim with LOI
VIEW CONFIG
ZERO TRIM
UNITS
RERANGE
LOOP TEST
DISPLAY
EXTENDED MENU
EXIT MENU
Go to EXTENDED MENU → CALIBRAT → LOWER TRIM to select the lower trim value. Go
to EXTENDED MENU → CALIBRAT → UPPER TRIM to select the upper trim value.
Reference Manual
adjustment of the lower value.
Sensor Trim in Step 2.
Calibrate, and under Sensor Trim, select Lower Sensor Trim.
cursor over Calibrate, and under Sensor Trim, select Upper Sensor Trim.
Figure 5-2 to perform an upper and lower sensor trim.
EXTENDED MENU
CALIBRAT
DAMPING
TRANSFER FUNCT
SCALED VARIAB
ASSIGN PV
TAG
ALARM SAT VALUES
PASSWORD
SIMULATE
HART REV
BACK TO MENU
EXIT MENU
Operation and maintenance
August 2019
CALIBRAT
ZERO TRIM
LOWER TRIM
UPPER TRIM
ANALOG TRIM
FACTORY RECALL
BACK TO MENU
EXIT MENU
91