Microchip Technology Power Debugger Manual page 19

Table of Contents

Advertisement

The plot above was captured while reprogramming the target. What can we see from this plot?
Two negative power pulses are seen (the device is pulled into Reset)
Four positive pulses are seen (read ID, erase, program Flash, and verify Flash)
The new application starts to execute
Leaving the application to run for a few seconds should give you a plot similar to this one:
What can we see from this plot?
The kit now draws about 6 mA with the LED OFF
Current draw increases to about 9 mA when the LED is pulsed ON
The 1% duty cycle still seems approximately correct
Result:  Power consumption has been significantly improved by clocking the device slower.
©
2020 Microchip Technology Inc.
User Guide
Power Debugger
Detailed Use Cases
DS40002201A-page 19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Power Debugger and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents