Checking And Adjusting The Throttle Cable; Checking And Adjusting The Choke Cable; Adjusting Of The Differential Lock - Husqvarna Rider ProFlex 21 II Operator's Manual

Checking and Adjusting the
Throttle Cable
Check that the engine responds to throttle
increases and that a good engine speed is
attained at full throttle.
If doubts arise, contact your service
representative.
If adjustments are necessary, they can be
made as follows for the lower cable:
1. Loosen the clamping screw for the
cable's outer casing and move the
throttle to the full throttle position.
2. Check that the throttle cable is mounted
in the correct hole in the lower lever, see
illustration.
3. Push the throttle cable outer casing as
far to the left as possible and tighten the
clamping screw.
Checking and Adjusting the Choke
Cable
If the engine produces black smoke or is
difficult to start, this can be because the choke
cable is incorrectly adjusted (upper cable).
If doubts arise, contact your service
representative.
If adjustments are necessary, they can be
made as follows:
1. Loosen the clamping screw for the
cable's outer casing and move the choke
lever to the full choke position.
2. Check that the choke cable is mounted
in the upper lever, see illustration.
3. Pull the choke cable outer casing as far
to the right as possible and tighten the
clamping screw.

Adjusting of the Differential Lock

The differential lock (on the left side) is
adjusted in the following manner:
1. Check that the differential lock is disen-
gaged; the pedal should be all the way up.
2. Adjust the zero play between the cable cas-
ing and the adjustment screw with the two
nuts on the adjustment screw. You should
feel no play when you pull the casing.
3. Tighten the nuts moderately to avoid
damaging the threads.
30
English-
MAINTENANCE
8009-176
8009-177
6020-011