Table of Contents
Advertisement
Checking and Adjusting the Throttle
Cable
Check that the engine responds to throttle
increases and that a good engine speed is attained
at full throttle.
If adjustments are necessary, they can be made as
follows for the lower cable:
1.
Loosen the clamping screw for the cable's
outer casing and move the throttle to the full
throttle position.
2.
Check that the throttle cable is mounted in the
correct hole in the lower lever, see illustration.
3.
Push the throttle cable's outer casing as far to
the left as possible and tighten the clamping
screw.
Checking and Adjusting the Choke
Cable
If the engine produces black smoke or is difficult
to start, this can be because the choke cable is
incorrectly adjusted (upper cable).
If adjustments are necessary, they can be made
as follows:
1.
Loosen the clamping screw for the cable's
outer casing and move the choke lever to
the full choke position.
2.
Check that the choke cable is mounted in
the upper lever, see illustration.
3.
Pull the choke cable's outer casing as far to
the right as possible and tighten the
clamping screw.
Replacing the Articulated Steering
Bearings
1.
Remove the engine as previously
described "Removing the Engine" on
page 31.
2.
Jack up the rider in front of the
articulated steering.
3.
Remove the belt guide and skid guard if
fitted.
4.
Pull off the drive belt from the engine's
belt side.
42
English-
REPAIR INSTRUCTIONS
Throttle cable
Choke cable
Jacking up
Belt guide
Advertisement
Table of Contents
