Connecting To A 64-Pin 0.5-Mm-Pitch Foot Pattern - Renesas M30290T-EPB User Manual

M30290T-EPB User's Manual

3.4.3 Connecting to a 64-pin 0.5-mm-pitch Foot Pattern

Here following is a procedure of connecting to a 64-pin 0.5-mm-pitch foot pattern on the user system using the
M30291T-64FPD (included with the M30291T-EPB-HP). For details on the M30291T-64FPD, refer to its user's
manual.
(1) Mount the NQPACK064SD-ND included with the M30291T-64FPD to the user system.
(2) Attach the YQPACK064SD included with the M30291T-64FPD to the NQPACK064SD-ND and secure it with the
YQ-GUIDE's.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M30290T-EPB.
(4) Attach the M30291T-64FPD to the YQPACK064SD.
Figure 3.12 Connecting to a 64-pin 0.5-mm-pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the
emulator and targets system.
The connectors of the M30290T-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
(1) Debugging
(3)
M30290T-PTCB
YQ-GUIDE (x4) *
YQPACK064SD *
NQPACK064SD-ND *
: No. 1 pin
* :These products are included with the M30291T-64FPD package.
M3T-FLX160-EPB
M30290T-EPB
M30291T-64FPD
(2) On-board evaluation
(4)
MCU with on-chip
flash memory etc.
(2)
(1)
64-pin 0.5-mm-pitch
(64P6Q-A) foot pattern
CAUTION
( 34 / 58 )
HQPACK064SD
(not included)