JUMO AQUIS touch P Installation Instructions Manual page 13

Modular multichannel measuring device for liquid analysis with integrated controller and paperless recorder

Hide thumbs Also See for AQUIS touch P:

Table of Contents

Step

Action

Connect the ends of the wires forming the conductor loop of the

calibration adapter.

Set the calibration adapter to the resistance value shown in the in-

struction text in the display (in the example: 20kΩ). Once the mea-

surement displayed has stabilized, confirm by pressing "OK".

Follow the

instructions

Now follow the instructions on the display.

You will be requested to set certain resistance values on the cali-

bration adapter one at a time and then to confirm each measuring

by pressing "OK".

All resistance value set on the calibration adapter are measured for

the end of one measuring range and the beginning of the following

measuring range. Each resistance value will thus be confirmed 2

times. Only the last measuring will be confirmed 1 time.

10 Retrofitting optional boards

Table of Contents

202580